The CW Coil Winder is the most revolutionary, ultra functionary micro-coiler that will create tight, uniform coils in just seconds. Build from 20-28 Gauge round kanthal wire with just a twist of your finger.
-Revolutionary Patent Pending Micro Coiling Technology - makes coils a breeze.
-Simply trap your wire, rotate the top cap, and you get that perfect micro coil in seconds--each and every time!
-Lightweight and portable--perfect for traveling and on the go!
-Unique styling with three colors, each representing a different coil size.
-CW-20 - for 2 mm coils, CW-25 - for 2.6mm coils, CW-30 - for 3mm coils.
By far one of the most innovative and revolutionary products of the year!
Made In The USA.
1: Insert the socket screw into the appropriate hole of the winder section.
- For 26 to 28 gauge wire, use hole number 1.
- For 20 to 24 gauge wire, use hole number 2.
2: Insert wire through hole on the side of the handle. Leave about 1/2" of the wire protruding from the hole. Hold the end of the wire against the handle so it won't pull through.
3: Pull the loose end of the wire around the shaft.
4: Slide the winder section over the shaft with the pin facing toward the handle.
5: Turn the winder section so that it catches the wire and starts wrapping it around the shaft. Keep light pressure against handle while winding. Excessive pressure will force smaller gauge wire to wrap over itself.
6: When finished, remove winder and straighten the wire end that protrudes from the hole in the handle.
7: Push up on the wire to slide coil up. Carefully grab the coil at the bottom to slide it off the shaft.